Detailed Discussions Of Bit; Sssw-Sw04; List Of Functions - Canon mf6600 Series Service Manual

SSSW-SW04

List of Functions

■
Bit Function
0 not used
1 not used
the number of final flag sequences of
2
protocol signals
3 Reception mode after CFR signal
transmission
4 the length of the period of ignoring
low speed signals after CFR output
5 not used
6 CNG signal for manual transmission Not transmitted
7 CED signal for manual reception
■

Detailed Discussions of Bit 2

Use it to select the number of last flag sequences for a protocol signal (transmission speed
at 300 bps). Select '2' if the other party fails to receive the protocol signal properly.
MEMO:
Any of the following error codes may be indicated at time of transmission
##0100, ##0280, ##0281, ##0750, ##0753, ##0754, ##0755, ##0758, ##0759, ##0760,
##0763 ##0764, ##0765, ##0768, ##0769,##0770, ##0773, ##0775, ##0778, ##0780,
##0783, ##0785, ##0788
■
Detailed Discussions of Bit 3
Use it to select an appropriate reception mode after transmission of the CFR signal.
If errors occur frequently at time of reception because of the condition of the line, select
'high speed' for reception mode and, at the same time, selects 'do not receive' for 'ECM
reception.'
8
Service Mode > Service Soft Switch Settings (SSSW) > SSSW-SW04 > Detailed Discussions of Bit 7
1 0
- -
- -
2 1
high speed/low speed
high speed
1500 ms 700 ms
- -
Transmitted
Not transmitted Transmitted
T-8-19 T-8-19
8 Service Mode > Service Soft Switch Settings (SSSW) > SSSW-SW04 > Detailed Discussions of Bit 7
MEMO:
Any of the following error codes may be indicated at time of reception because of line
condition
##0107, ##0114, ##0201
Be sure to change bit 4 before changing this bit; if errors still occur, change this bit.
When 'high speed' is selected, only high-speed signals (images) will be received after
transmission of the CFR signal.
■
Detailed Discussions of Bit 4
Use it to select the time length during which low-speed signals are ignored after
transmission of the CFR signal.
If the condition of the line is not good and, therefore, the reception of image signals is
difficult, select '1500 ms.'
■
Detailed Discussions of Bit 6
Selects whether or not to transmit CNG signal during manual transmission.
In manual transmitting to a fax with the FAX/TEL switching mode, if there are frequent
errors due to failure to switch to fax mode, select "Transmitted" for the CNG signal.
■
Detailed Discussions of Bit 7
Selects whether or not to transmit CED signals during manual reception. If the other fax
does not transmit even when you start manual reception, select "Transmitted" for the CED
signal.
8-8
8-8