Canon mf6600 Series Service Manual page 124

4
Disassembly/Assembly > Controller System > Removing the Engine Controller Unit (TYPE II) > Procedure
10) While Pulling Out the Flat Cable [1] and the Harness [2] from the Hole Of the Host
Machine, Remove the Engine Controller Unit [3].
[3]
11) Remove the Engine Controller PCB [1].
4 Screws [2]
•
x4
[2]
4 Disassembly/Assembly > Controller System > Removing the Engine Controller Unit (TYPE II) > Procedure
[2]
[1]
[1]
[2]
F-4-149
Removing the Engine Controller Unit (TYPE II)
■
Preparations
1) Removing the Right Cover.(Refer to page 4-23)
2) Removing the Left Cover.(Refer to page 4-19)
3) Removing the Left Rear Cover.(Refer to page 4-22)
4) Removing the Controller Cover.(Refer to page 4-55)
5) Removing the NCU PCB.(Refer to page 4-58)
6) Removing the ADF/Reader Driver PCB.(Refer to page 4-55)
7) Removing the Main Controller Board.(Refer to page 4-56)
8) Removing the Controller Box.(Refer to page 4-62)
9) Removing the Rear Cover Unit.(Refer to page 4-27)
■
Procedure
F-4-148
1) Remove the Duplex Reverse Sensor Unit [1].
1 Connector [2]
•
1 Cable Clip [3]
•
1 Guide [4]
•
1 Screw [5]
•
[1]
x2
[3]
[5] [4]
4-67
[2]
F-4-150
4-67