Canon mf6600 Series Service Manual page 197

SSSW-SW13
List of Functions
■
Bit Function
0 not used
1 not used
Convert "inch" into "mm" when
2
transmitting the received image data
3 not used
4 not used
5 not used
6 not used
7 not used
■
Detailed Discussions of Bit 2
It converts "inch" into "mm" when transmitting the received image data.
Scanning direction in conversion follows the Bit 2 setting of SW14.
8
Service Mode > Service Soft Switch Settings (SSSW) > SSSW-SW14 > Detailed Discussions of Bit 4
1 0
- -
- -
convert do not convert
- -
- -
- -
- -
- -
T-8-24 T-8-24
8 Service Mode > Service Soft Switch Settings (SSSW) > SSSW-SW14 > Detailed Discussions of Bit 4
SSSW-SW14
List of Functions
■
Bit Function
0 not used -
1 not used -
2 direction of scanning for both main and sub
inch/mm conversion scanning directions
3 not used -
inch-configuration
4 declare
resolution declaration
5 not used -
6 not used -
7 not used -
■
Detailed Discussions of Bit 2
Use it to specify whether to convert or not convert an inch-configuration resolution into a
millimeter-configuration resolution for image read in G3 transmission: either in sub scanning
direction only or in both main and sub scanning directions. The setting is valid only when bit
1 of SW05 of #SSSW is set to '1'.
■
Detailed Discussions of Bit 4
Use it to specify whether to declare or not declare an inch-configuration resolution to the
other machine for G3 communication: if 'declare' is selected, the machine will indicate that
it reads and records at an inch-configuration resolution using the DIS, DCS, or DTC signal.
8-10
1 0
-
-
sub scanning direction
only
-
do not declare
-
-
-
T-8-25 T-8-25
8-10