Network Connectivity - Lorex SG17F6584 Instruction Manual

Network Connectivity

The SG17F6584 Observation System can be remotely controlled using your existing network
and the provided NetViewer software.
1. Connect the Observation System to
the Router using the supplied
Ethernet Cable.
Observation unit on.
NOTE: The Observation System
must be connected to the router
prior to powering on the system.
This allows the system to
communicate on your network
2. Set up a web account at
DDNS.strategicvista.net. Refer to
Pages 26 - 27 for setup and
configuration instructions.
3. Install the NetViewer software on
your PC. See Page 24 for
installation requirements, and refer
to the provided 'NetViewer Guide'
with your product for details on
using the software.
4. Find the IP address of your
Observation using the Lorex IPEdit
application. See Page 28 for details
5. Enable PORT FORWARDING on
your Router. Refer
instructions on Page 29 for details.
Power the
http://
to the
OBSERVATION SYSTEM
INTERNET
PC
(Not Included)
Network Connectivity
ROUTER
(Not Included)
25