Network Connectivity
The SG15F6584 Observation System can be remotely controlled using your existing network and
the provided NetViewer software.
1. Connect the Observation System to
the Router using the supplied
Ethernet
Cable.
Observation unit on.
NOTE: The Observation System
must be connected to the router
prior to powering on the system.
This allows the system to
communicate on your network
2. Set up a web account at
DDNS.strategicvista.net. Refer to
Pages 34 - 35 for setup and
configuration instructions.
3. Install the NetViewer software on
your PC. See Page 32 for
installation requirements, and refer
to the provided 'NetViewer Guide'
with your product for details on
using the software.
4. Find the IP address of your
Observation using the Lorex IPEdit
application. See Page 36 for details
5. Enable PORT FORWARDING on
your
Router.
Refer
instructions on Page 37 for details.
Power
the
http://
to
the
OBSERVATION SYSTEM
INTERNET
PC
(Not Included)
Network Connectivity
ROUTER
(Not Included)
33