Network Service Check - Lexmark MS510 Service Manual

Action
Step 3
Try a different application to run a print job.
Did the output print?
Step 4
Check the printer driver.
Is the correct driver being used and properly set up?
Step 5
Use a different driver.
Did this fix the issue?
Step 6
Try a different USB cable.
Did this fix the issue?
Step 7
Replace the controller board. Go to
page 200.
Did this fix the issue?

Network service check

Note: Before starting this service check, print out the network setup page. This page is found under Menu >
Reports > Network Settings. Consult the network administrator to verify that the physical and wireless network
settings displayed on the network settings page for the device are properly configured. If a wireless network is used,
then verify that the printer is in range of the host computer or wireless access point, and there is no electronic
interference. Have the network administrator verify that the device is using the correct SSID, and wireless security
protocols. For more network troubleshooting information, consult the Lexmark Network Setup Guide.
Actions
Step 1
If the device is physically connected to the network, verify that the
Ethernet cable is properly connected on both ends.
Is the cable properly connected?
Step 2
Connect the Ethernet cable.
Does this fix the problem.
"Controller board removals" on
Diagnostic information
122
Yes No
This is not a printer Go to step 4.
issue.
Go to step 6. Go to step 5.
The problem is solved. Go to step 6.
The problem is solved. Go to step 7.
The problem is solved. Contact the next level
support
Yes No
Go to step 3. If the Go to step 2.
network is wireless,
then go to step 3.
The problem is solved. Go to step 3.
4514-6xx