Stihl RMA 370 Instruction Manual page 30

English
Charging times
AL 100
with AP 80:
– up to 80 % capacity: 70 min
– up to 100 % capacity: 100 min
with AP 160:
– up to 80 % capacity: 150 min
– up to 100 % capacity: 165 min
AL 300
with AP 80:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 50 min
with AP 160:
– up to 80 % capacity: 35 min
– up to 100 % capacity: 60 min
Cutting blades
Speed: 3,100 rpm
Cutting width: 14 1/2"
(37 cm)
Grassbox
Capacity: 1.4 cu.ft (40 l)
Weight
without battery: 28.7 lbs
(13 kg)
28
Transporting
STIHL batteries comply with the
requirements laid down in UN-Manual
ST/SG/AC.10/11/Rev.5/Part III,
Subsection 38.3.
No further condition have to be fulfilled
by the user to transport STIHL batteries
by road to the power's tool operating
site.
Country-specific regulations must be
observed for transport by air or sea.
For further notes on transportation see
www.stihl.com/safety-data-sheets
FCC 15 Compliance Statement for
power tool and charger
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
this device may not cause harmful
–
interference
this device must accept any
–
interference received, including
interference that may cause
undesired operation
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
reorient or relocate the receiving
–
antenna
increase the separation between
–
the equipment and receiver
connect the equipment into an
–
outlet on a circuit different from that
to which the receiver is connected
consult the dealer or an
–
experienced radio/TV technician for
help
Do not change or modify this product in
any way unless specifically allowed in
this manual, since this could void your
autority to operate it.
RMA 370