Fc 5094 - Display Panel - Nb1 - IBM iSeries 270 Service Manual

a. Power off the system (see Power on/off the system and logical partitions).
b. Disconnect the power cord.
c. Pinch the two surfaces of the latching mechanism together and pull the handle towards you to
release the disk unit from the slot.
d. Remove the unit from the tower.
5. Are you finished with the repair?
v No: Continue with the next step.
v Yes: Replace the covers that were removed during this procedure and return to the procedure that
sent you here.
This ends the procedure.
6. Install the disk unit by performing the following:
a. Power off the system (see Power on/off the system and logical partitions).
b. Disconnect the power cord.
c. Put the disk unit part way into the desired slot and rotate the handle of the disk unit towards you.
d. Push the disk unit completely into the slot and rotate the handle towards the disk unit to latch it into
the slot.
e. Replace the covers that were removed during this procedure and return to the procedure that sent
you here.
This ends the procedure.

FC 5094 - Display panel - NB1

For use by authorized service providers.
Use this procedure to remove or replace the display panel - NB1 in an FC 5094.
Attention: The display panel is sensitive to electrostatic discharge. See Work with electrostatic
discharge-sensitive parts.
Analyze hardware problems
183