IBM iSeries 270 Service Manual page 278

Position FRU name
A02 AC module
P01 - P03 Power supply
P01 - P02 Power supply
PB1 Power board
T01 - T04 Battery
DB1 Device board
DB2 Device board
DB3 Device board
NB1 Control panel
D01 - D40 Disk unit
D41 Optical
D42 Tape
D46 - D50 Disk unit
HSL cables HSL cable
on the HSL
ports
Figure 2. Dual line cord drawing for System Models 830, SB2
266
Hardware (Remove and Replace; Part Locations and Listings)
Type, CCIN, or part
number (use the Type,
model, and part number
list to determine the part
Possible failing number when the type or
component CCIN are given.)
AC module 21P6347 - Dual line cord
Power supply 90H6629 - Single line cord
Power supply 53P1038 - Dual Line Cord
Power board 24L0891
Battery 97H7318 (This PN includes
all four batteries.)
Device board 283D (See page 526) or
28CC (See page 528)
Device board 283D (See page 526) or
28CC (See page 528)
Device board 283C (See page 526) or
28CB (See page 528)
Control panel 24L0945
Disk unit See the Type, model, and
part number list.
Optical See the Type, model, and
part number list.
Tape See the Type, model, and
part number list.
Disk unit See the Type, model, and
part number list.
HSL connection See the Type, model, and
part number list.
Remove and replace or
recovery procedure
Go to Model 830 FC 9074, Model
840 FC 9079/8079 (with dual line
cords) - AC module (A01, A02).
Go to FC 9074, FC 9079, FC
5074/5079 - Power supply - P01,
P02, and P03.
Go to FC 9074, FC 9079, FC
5074/5079 - Power supply - P01,
P02, and P03.
Go to Models 830/SB2 with FC
9074 - Power distribution
backplane (PB1).
Go to Models 830/SB2 with FC
9074 - Battery (T01 through T04).
Go to Models 830/SB2 - Device
boards (DB1 and DB2).
Go to Models 830/SB2 - Device
boards (DB1 and DB2).
Go to Models 830/SB2 - Device
board (DB3).
Go to Models 830/SB2 with FC
9074 - System unit control panel
(NB1).
Go to Recovery procedures.
Go to Models 830/SB2 with FC
9074 - Removable media (D41 &
D42).
Go to Models 830/SB2 with FC
9074 - Removable media (D41 &
D42).
Go to Recovery procedures.
Go to HSL cables - Concurrent.