Fc 5075 Remove And Replace Procedures; Fc 5075 - Air Moving Device - B01 And B02 - IBM iSeries 270 Service Manual

h. Power the expansion unit back on. See the Expansion unit power procedure.
10. After exchanging an item, go to Verify the repair.
This ends the procedure.

FC 5075 Remove and replace procedures

For use by authorized service providers.
FC 5075 - Air moving device - B01, B02
FC 5075 - Cards (concurrent)
FC 5075 - Cards (dedicated)
FC 5075 - Covers
FC 5075 - Device board - DB1
FC 5075 - Disk Unit (concurrent)
FC 5075 - Disk unit (dedicated)
FC 5075 - Display panel - NB1
FC 5075 - Power distribution board - PB1
FC 5075 - Power supply - P01 and P02
FC 5075 - SPCN card - SB1
FC 5075 - Tower card - CB1

FC 5075 - Air moving device - B01 and B02

For use by authorized service providers.
Use this procedure to remove or replace the air moving device (AMD) - B01 and B02 in an FC 5075.
To remove or replace the air moving device (B01 and B02):
1. Are there two AMDs installed in the tower?
v Yes: Continue with the next step.
v No: Perform the following:
a. Power down the expansion tower, see Power on/off the system and logical partitions.
b. Remove the power cord from the rear of the tower.
c. Continue with the next step.
2. Remove the front cover. See FC 5075 - Covers.
3. Pull the black knob on the front of the AMD casing.
4. Pull open and remove the AMD. The power connection will undock automatically.
5. Install the AMD by reversing the removal procedure. After exchanging an item, go to "Verify the repair"
on page 558.
This ends the procedure.
Analyze hardware problems
155