Fc 5074, Fc 5079, Fc 5094, Fc 5294, Fc 9079, Fc 9094 - Covers - IBM iSeries 270 Service Manual

FC 5074, FC 5079, FC 5094, FC 5294, FC 9079, FC 9094 - Covers

For use by authorized service providers.
Use this procedure to remove or replace covers on the FC 5074, FC 5079, FC 5094, FC 5294, FC 9079,
FC 9094.
Note: The front and rear covers will swing open a little more than 90 degrees. This makes it possible to
replace all FRUs, without having to remove the covers.
v To open or remove the front cover, refer to Figure 1. Front cover - removal (See page ) below.
v To open or remove the rear cover, refer to Figure 2. Rear cover - removal (See page ) below.
Perform the following steps to open or remove each cover.
1. Unlock the cover (front only).
2. Open the cover by grasping its right side and pulling it towards you.
3. After opening the cover, press down on lever B, which is located inside along the top, left side of the
cover.
4. Tilt the top of the cover away from the tower, and lift the cover off.
This ends the procedure.
Figure 1. Front cover - removal
Figure 2. Rear cover - removal
Analyze hardware problems
177