Insert The Live! Drive Ir Into The System - Creative Live! PLATINUM 5.1 Product Manual

If a particular INPUT source (for example, Line In 2) is supported by the
Live! Drive IR as well as the Digital I/O card, only the input on the Live!
Drive will be enabled. However, using the microphone via the Line In
2/Mic In 2 input on the Live! Drive IR will also disable the Line In 2
input on the Digital I/O card.
To connect to your existing computer headphones and microphone to the
Live! Drive IR, use the ¼" to 3.5mm adapter provided.
It is recommended to lower the gain level of the Mic In 2 jack to the
minimum before connecting a microphone.

Insert the Live! Drive IR into the System

1. Pass the following cable ends from the inside of the casing through
the vacant 5¼" drive bay, and then leave the cables dangling
halfway on the outside of the casing:
Smaller end of the power splitter cable
Dark grey flat cable end with a black circle near the connector
(Optional) Any end of the light grey flat cable (if you want to
connect to a Digital I/O card from an earlier purchase)
(Optional) Cable end of the Digital DIN metal bracket (if you
want to connect to FPS2000, DTT2500 or DTT3500 speakers)
For optional accessories please see the online User's Guide
6 SB Live! Platinum 5.1