ZyXEL Communications MES3500 series User Manual page 310

Figure 196 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 148 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Note that as you type a password, the screen displays an asterisk (*) for each character
you type.
Set Community Enter the Set Community, which is the password for incoming Set- requests from the
management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Note that as you type a password, the screen displays an asterisk (*) for each character
you type.
Trap Community Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Note that as you type a password, the screen displays an asterisk (*) for each character
you type.
Trap Destination Use this section to configure where to send SNMP traps from the Switch.
Chapter 40 Access Control
MES3500 Series User's Guide
310