ZyXEL Communications MES3500 series User Manual page 25

If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
3
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the Switch with the connection
4
cables.
Align the holes on the back of the Switch with the screws on the wall. Hang the Switch on the
5
screws.
Figure 7 Wall Mounting Example
Chapter 2 Hardware Installation and Connection
MES3500 Series User's Guide
25