ZyXEL Communications MES3500 series User Manual page 129

The following table describes the labels in this screen.
Table 36 Advanced Application > Spanning Tree Protocol > MSTP
LABEL DESCRIPTION
Port Click Port to display the MSTP Port Configuration screen (see
Status Click Status to display the MSTP Status screen (see
Active Select this check box to activate MSTP on the Switch. Clear this checkbox to disable MSTP
on the Switch.
Note: You must also activate Multiple Spanning Tree in the Advanced Application >
Hello Time This is the time interval in seconds between BPDU (Bridge Protocol Data Units)
configuration message generations by the root switch. The allowed range is 1 to 10
seconds.
MaxAge This is the maximum time (in seconds) a switch can wait without receiving a BPDU before
attempting to reconfigure. All switch ports (except for designated ports) should receive
BPDUs at regular intervals. Any port that ages out STP information (provided in the last
BPDU) becomes the designated port for the attached LAN. If it is a root port, a new root
port is selected from among the Switch ports attached to the network. The allowed range
is 6 to 40 seconds.
Forwarding Delay This is the maximum time (in seconds) a switch will wait before changing states. This
delay is required because every switch must receive information about topology changes
before it starts to forward frames. In addition, each port needs time to listen for
conflicting information that would make it return to a blocking state; otherwise,
temporary data loops might result. The allowed range is 4 to 30 seconds. As a general
rule:
Note: 2 * (Forward Delay - 1) >= Max Age >= 2 * (Hello Time + 1)
Maximum hops Enter the number of hops (between 1 and 255) in an MSTP region before the BPDU is
discarded and the port information is aged.
Configuration Enter a descriptive name (up to 32 characters) of an MST region.
Name
Revision Number Enter a number to identify a region's configuration. Devices must have the same revision
number to belong to the same region.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Instance Use this section to configure MSTI (Multiple Spanning Tree Instance) settings.
Instance Enter the number you want to use to identify this MST instance on the Switch. The Switch
supports instance numbers 0-64.
Bridge Priority Set the priority of the Switch for the specific spanning tree instance. The lower the
number, the more likely the Switch will be chosen as the root bridge within the spanning
tree instance.
Enter priority values between 0 and 61440 in increments of 4096 (thus valid values are
4096, 8192, 12288, 16384, 20480, 24576, 28672, 32768, 36864, 40960, 45056, 49152,
53248, 57344 and 61440).
Chapter 13 Spanning Tree Protocol
Spanning Tree Protocol > Configuration screen to enable MSTP on the Switch.
MES3500 Series User's Guide
129
Figure 68 on page
Figure 69 on page 132).
131).