ZyXEL Communications MES3500 series User Manual page 286

Use this screen to configure DHCPv6 relay settings for a specific VLAN on the Switch. Click IP
Application > DHCP > DHCPv6 in the navigation panel to display the screen as shown.
Figure 183 IP Application > DHCP > DHCPv6
The following table describes the labels in this screen.
Table 133 IP Application > DHCP > DHCPv6
LABEL DESCRIPTION
VID Enter the ID number of the VLAN you want to configure here.
Helper Address Enter the remote DHCPv6 server address for the specified VLAN.
Options Profile Select a pre-defined DHCPv6 options profile that the Switch applies to all ports in this VLAN.
The Switch adds the interface-ID sub-option, remote-ID sub-option and/or subscriber-ID
sub-option specified in the profile to DHCP requests that it relays to a DHCP server.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to their last saved values.
Clear Click Clear to reset the fields to the factory defaults.
VID This field displays the VLAN ID number. Click the VLAN ID to change the settings.
Helper Address This field displays the IPv6 address of the remote DHCPv6 server for this VLAN.
Profile Name This field displays the DHCPv6 options profile that the Switch applies to the port(s) in this
VLAN.
Delete Select the entry(ies) that you want to remove in the Delete column, then click the Delete
button to remove the selected entry(ies) from the table.
Cancel Click this to clear the check boxes in the Delete column.
Chapter 37 DHCP
MES3500 Series User's Guide
286