Battery Installation And Charging - VTech VSP601 User Manual

IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a
replacement power adapter, visit our website at
businessphones.vtech.com
2. The power adapter is intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.

Battery installation and charging

Install the battery as shown on the following page. Once you have installed
the battery, the screen indicates the battery status (see the table below). If
necessary, place the handset in the charger to charge the battery. For best
performance, keep the handset in the charger when not in use. The battery is
fully charged after 11 hours of continuous charging.
If the screen is blank, you need to charge the handset without interruption for
at least 30 minutes to give the handset enough charge to use the telephone for
a short time. When the battery is low, the handset shows Low battery and a
flashing .
Battery indicators
The screen is blank or
shows Place in charger
and flashes.
The screen shows Low
battery and flashes.
Full battery icon ( )
appears.
or call
Battery Status
The battery has no
or little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
13
1 (888) 370-2006
Charge without
interruption (at least 30
minutes).
Charge without
interruption (at least 30
minutes).
To keep the battery
charged, place it in the
charger when not in use.
.
Action