Table of Contents
Advertisement
Getting started
Battery installation and charging
Install the battery as shown below. The battery may have enough charge for short
calls. For best performance, charge the handset for at least 16 hours. When the
battery power is low, the handset will beep, display LOW BATTERY and
flash on the handset screen. Place the handset in the telephone base or charger
to charge the battery when not in use. When fully charged, the handset battery
provides approximately nine hours of talk time or five days of standby time.
1.
Insert the plug of the battery as indicated. Make sure it is plugged securely
and matches the color-coded label inside the battery compartment.
Place the battery with the label THIS SIDE UP facing up and the wires inside
2.
the battery compartment.
3.
Align the cover flat against the battery compartment, then slide it upwards
until it clicks into place.
4.
Charge the handset by placing it in the telephone base or charger. The handset
charge light will be on when charging.
1
2
www.vtechphones.com
Charge light
4
3
•
If the handset
will not be used
for a long time,
will
disconnect and
remove the battery
to prevent possible
leakage.
•
To purchase
replacement
batteries, visit our
website at www.
vtechphones.
com or call
1 (800) 595-9511.
In Canada, go to
www.vtechcanada.
com or call 1 (800)
267-7377.
3
Advertisement
Table of Contents
