Samsung SW12E1S(P)/XST Service Manual page 8

2-3 Main Functions
2-3-1 Washing Cycle
1. Water Supply Mode
1) In the water supply mode of each cycle, the valve for the corresponding water supply is on according to the water supply selec-
tion until the selected water level is reached.
2) The water level selection is as follows.
Reset
25.20
3) The selection of the water supply valve-ON for each cycle according to the water supply stated in Paragraph 1) is as follows.
Water Supply Selection
Cold water
Hot, Cold water
Hot water
Note) 1. When only the hot water is selected, for the initial 20 sec of supplying water at the beginning of washing, the cold water
valve is on.
To avoid the damage of the cloth and to solve the detergent completely
2. While in rinsing, the water supply selection is applied only to the Rinsing 1 as shown in the table above. In the Rinsing
2 or later, only cold water is supplied.
4) While supplying water, the corresponding lamp is ON/OFF at 1 sec interval. When the water supply is done, the corresponding
lamp is on.
5) When supplying water is not done after the standard time allotted for supplying water is over, the remaining time does not
decrease.
6) When supplying water is done before the standard time allotted for supplying water is not over, the remaining time is compelled
to decrease according to the allotted time and then the next cycle starts.
7) When supplying water is not done 60 min later after starting the water supply, the Water Supply Error mode is carried out.
(including the water supply or the additional water supply for clearing the unbalance)
8) After supplying water is done, if the water level key is input and the selected level is higher than the previous one, water is sup-
plied to the selected level. Meanwhile, the motor is off and the remaining time is not reduced while in supplying water.
9) Table of Water Supply Time for Each Water Level
Water Level
Water Supply Time
10) While in operation, if the water level drops below the reset, water is supplied to the selected water level and then the operation
proceeds.
11) When the water level reaches the one that is one level lower than the selected level while in supplying water, the motor starts to
run with the default water current pattern. When the selected water level + 200 Hz are reached, the motor is off. (excluding the
small water level or lower)
* 1. Motor running time out 30 sec
2. This procedure is carried out in washing or rinsing as well.
6
Minimum Small
23.76 23.21
Washing
Cold water
Hot, Cold water Hot, Cold water
Hot water Hot, Cold water
High Medium
5 min 4 min 30 sec
Low
22.75
Rinsing 1 Rinsing 2, 3
Cold water Cold water
Cold water
Cold water
Low Small
4 min 2 min 30 sec
(Unit: water amount-l, Frequency: KHz)
Medium High
22.12 21.9
Added Water
Following the water supply
selection for each of Washing,
Rinsing 1, Rinsing 2/3
Minimum Remarks
1 min 30 sec
SAMSUNG WASHING MACHINE