Samsung SW12E1S(P)/XST Service Manual page 20

6-2 Replacement of pressure-sensor, water-valve, checker-ass'y, ass'y-detergent
1) After removing the 2 screws that fasten the top-cover and the
cover-T.C. together, gently push the cover-T.C. to the direction
of the arrow in the figure to separate it.
Remove the 3 screws (2 on the rear, 1 on the front) that
fasten the top-cover and the out-case together, gently
raise the rear side, and push it to the front in order to sep-
arate the top-cover and to turn it over.
Before turning over the top-cover, remove the screw that
fastens the earth-wire.
2) Pressure-sensor
After pulling out the terminal of the pressure-sensor lead-wire,
widen the hook to remove the sensor.
While assembling the pressure-sensor, ensure that the air-
hose is not kinked and connected properly.
3) Water-valve
Remove the 3 terminals of the water-valve lead-wire. Then
remove the 3 screw-taps, TH that fasten the water-valve of the
ass'y-detergent inside the top-cover to disassemble the ass'y
water-valve.
Before assembling the water-valve, ensure that the seal-
detergent is not missing. (If the seal-detergent is missing,
water leaking occurs and it may cause the danger of a short.)
4) To disassemble the ass'y-detergent, turn over the top-cover
and remove the 2 screws.
5) After pulling out the terminal of the checker-S/W lead-wire,
remove the 2 screws that fasten the checker-S/W.
(Pull out the lead-wire terminal while pressing the hook.)
SAMSUNG ELECTRONICS CO., LTD
EARTH-WIRE
SCREW
21