Samsung SW12E1S(P)/XST Service Manual page 6

2. Rinse Addition Key
1) The input of this key is always effective except while in progress of the intermittent spin, the spin, or the pause mode.
2) After selecting the Rinse Only and before inputting the Start key, one is selected by touching this key as follows.
3) While in progress of the Rinse Only mode, if the Course key is pressed, only the key input sound is produced.
4) While in progress of the Rinse Only mode, if the Pause key is pressed and then the Course key is input, the Rinse Only mode
is cancelled to switch to the selected mode.
5) When the number of the rinsing cycles is changed, one previously carried out is canceled and the finally selected one is applied.
6) While in operation or after a pause, this key can be input until the final rinse is done just before the draining cycle starts.
3. Water Supply Key
1) The input of this key is always effective except in the Error mode.
2) Each time this key is pressed, one is selected in the following order.
3) When the water supply selection is changed by inputting this key, the selected water supply maintains even if the course is
changed.
When changed to the Wool course, automatically cold water is selected. However, when changed to another course again, the
previous water supply selection is applied again.
4) The Error in Paragraph 1) is as follows.
(1) Water Supply Error
5) While in supplying water, the lamp for the corresponding water supply flashes in the way of 1 sec ON/OFF.
4
One time Two times
(Same in the initial stage of Power On)
Cold water Hot & Cold water
(2) Draining Error
Three times Off
Hot water
SAMSUNG WASHING MACHINE