Samsung SW12E1S(P)/XST Service Manual page 12

2-4-2 Automatic Power Off Mode
1) After the end melody sounds when all the cycles are done, the automatic power relay off is carried out.
Meanwhile, '00' is displayed by 1-sec ON/1-sec OFF.
2-4-3 Softener Flushing Mode
1) The valve for flushing the softener is on as shown below.
Supplying water
RINSE
2) The softener is flushed at the final rinsing cycle. However, if the number of the rinsing cycles is adjusted to the higher number
while in flushing the softener, the valve for flushing softener is off and then water is supplied.
3) When the number of the rinsing cycles is adjusted to the higher number while in flushing the softener, flushing the softener stops.
Later when the final rinsing cycle starts, the softener is flushed for the remaining flushing time of the previous rinsing cycle.
4) When the pause mode is carried out while flushing the softener, flushing the softener stops. When restarted, the softener is
flushed for the remaining time.
2-4-4 Sudden Power Failure Mode
1) When the voltage is not detected while a cycle is in progress by the Start key input, all the drive parts are off in order to com-
pensate the sudden power failure. The steps of the cycle are paused in the same way when the Pause key is input. In other
words, the remaining time and the other steps are paused, but the display does not disappear.
2) When the power is restored, the paused cycle proceeds in the same way when the restart key is input.
However, the key input sound is not produced.
3) The power failure is detected when 60 Hz INT is not generated for 50 ms or longer. Clearing is carried out immediately after 60
Hz INT is generated for 450 ms.
10
ON
OFF
ON
OFF
10 5 10 5 10 5 10 5 15
SAMSUNG WASHING MACHINE