Samsung SW12E1S(P)/XST Service Manual page 11

2-4 Definition of Special Mode
2-4-1 Error Occurrence Mode
1. Water Level Sensor Error
1) When the water level sensor detects the frequency of below 15 KHz or above 30 KHz for 5 sec or longer, the water level sen-
sor error occurs.
2) Display: '1E', 0.5 sec ON/OFF
3) How to clear: Power key-ON
2. Power Relay Failure
1) When the power is not turned off by the automatic power off mode (This mode works only in the test mode.)
2) The error melody sounds 5 times.
3) Display: '2E', 0.5 sec ON/OFF
4) How to clear: : Power key-ON
3. Water Supply Error
1) When the selected water level is not reached in 60 min after supplying water begins
2) The error melody sounds 5 times.
3) Display: '4E', 0.5 sec ON/OFF
4) How to clear: Inputting the Start key to start supplying water again
4. Draining Error
1) When the water level does not drop below the reset in 15 min after draining begins.
2) The error melody sounds 5 times.
3) Display: '5E', 0.5 sec ON/OFF
4) How to clear: Inputting the Start key to start draining again
5. Door Open Error
1) When the door is open while in the mode of the intermittent spin or the spin
2) The error melody sounds 5 times.
3) Display: 'dE', 0.5 sec ON/OFF
4) How to clear: Closing the door
6. Unbalance Error
1) When the unbalance is detected for the third time during a spinning cycle
2) The error melody sounds 5 times.
3) Display: 'UE', 0.5 sec ON/OFF
4) How to clear: Opening and closing the door
7. Motor Failure Error
1) When a failure occurs in the primary motor TR1AC, the weight sensor circuit, or the motor
2) The error melody sounds 5 times.
3) Display: '3E', 0.5 sec ON/OFF
4) How to clear: High water level washing by the Start key input
SAMSUNG ELECTRONICS CO., LTD 9