Samsung SW12E1S(P)/XST Service Manual page 7

4. Start/Pause
1) Each time this key is input, one is selected in the following order.
Start Pause
2) This key carries out the Error canceling function.
(1) Water Supply Error
3) When restarting after a pause, the delay time of the drive part is as follows.
Operation Mode Drive Part
Water supply
Water Supply
valve
Mode
Rinse valve
Motor
Washing Mode
MR. ML
Draining
Draining/Stop
Motor
Draining
Spin Mode
Motor
(including
Motor
Intermittent
Spin)
(ML)
5. Water Level Key
1) The input of this key is always effective except in the Error mode.
Error: Water Level Sensor, Water Supply Error, Draining Error
2) Each time this key is input, one is selected in the following order.
Low Medium
3) When the Bedding course is selected, only the low water level or higher can be selected.
4) When the Wool course is selected, only the small water level or higher can be selected.
5) While a water level is selected, if the course is changed to the Wool or Bedding course after a pause, in case of the Bedding course, if
the previous water level is below the Low, the water level is automatically set to the High, however, if the previous water level is the Low
or higher, the previous water level is applied. In case of the Wool course, if the previous water level is below the Small, automatically
the high water level is set. However, if the previous water level is the Small or higher, the previous water level is applied.
6) After supplying water is done just before the motor runs, if the water level is changed by touching the water level key, the remain-
ing time is recalculated since the water supplying time for the corresponding water level is changed.
7) Changing washing time according to the water level in the Fuzzy course is applied only before the motor starts to run. After the motor
starts to run, washing is proceeded according to the washing time for the previous water level regardless of the water level change.
8) While — is displayed as the initial data in the Fuzzy course, by inputting the water level key, the remaining time for the corre-
sponding water level immediately appears.
However, if the Start key is input in the initial stage of the Fuzzy without inputting the water level key, — is displayed until the
weight sensing is done.
SAMSUNG ELECTRONICS CO., LTD
(2) Draining Error
Operation Mode Pause Mode
High Medium Low
Operation Mode
2 sec
2 sec
4 sec
10 sec
10 sec
Small Minimum Small
Remarks
The delay time when
carrying out the cancel-
ing function by the UNB
sensor is 10 sec.
5