Samsung SW12E1S(P)/XST Service Manual page 10

3. Spin Mode
1) This mode is carried out by turning the washing motor counterclockwise. The draining valve is kept on during the correspond-
ing spinning time.
2) The other functions are the same as those of the intermittent spin mode.
3) The spinning time after washing or rinsing, or the final spinning time is shown in the time chart.
4. Pause Mode
1) This mode is carried out by turning off ML for 1 min 30 sec and keeping the draining valve on.
2) When the door is open while in the pause mode of the rinsing cycle, the door open error occurs. When the door is closed again,
the restart mode is carried out.
3) When the door is open while in the pause mode of the final spinning cycle, the ending mode is carried out.
5. Draining Mode
1) The same as the draining mode of the washing cycle.
6. Rinsing Mode
1) When the selected water supply is done, rinsing starts according to the water level.
2) The rinsing time is 2 min 30 sec regardless of the number of rinsing cycles. However, in the Wool course, it is 2 min.
3) Table of Water Current Pattern during the rinsing cycle of each water level for each course (see the appendix)
2-3-3 Spinning Cycle
1) The same as the intermittent spin mode or the spin mode of the rinsing cycle.
2) In the Wool course, spinning is carried out by 10-sec ON and 5-sec OFF.
2-3-4 Ending Cycle
1) This mode is carried out when all the selected cycles are done.
2) While in this mode, the end melody sounds and all the drive parts are off.
Meanwhile, '00' is displayed by 1-sec ON/1-sec OFF.
3) When this mode ends, the automatic power relay off is carried out.
8 SAMSUNG WASHING MACHINE