Samsung SW12E1S(P)/XST Service Manual page 13

2-5 Test Program Mode
2-5-1 Test Mode 1 (Drive Part, Other Test)
1) How to enter: [Rinse Addition + Course + Power S/W ON]
2) Initial display after entering: All display
3) Each time the Rinse Addition key is input at the step 2), the mode is selected as shown below.
4) Mode 1 (Drive Part Test)
When the Start key is input while 01 is ON on 88-SEG, 01 remains on the display and each drive part is turned 1-sec
ON/OFF to check the condition of the drive part.
The operating procedures are as follows.
Cold water (Cold water LED ON)
L
* Note 1: is ON on 8-SEG
r
* Note 2: is ON on 8-SEG
5) Mode 2 (Spin Aging)
When the Start key is input while 02 is ON on the display, 02 remains on the display and only the spin is proceeded after
the delay time of the draining valve. The intermittent spinning operation is carried out only three times in the way of 3.5-sec
ON/4.5-sec OFF, 4-sec ON/4-sec OFF, 4-sec ON/4-sec OFF. When the door open error or the unbalance error occurs, it
is detected that ERROR appears on the display and the motor is turned off.
The sequential spinning procedures are carried out in the following order.
7-min ON
The draining mode is carried out by detecting the water level.
6) Mode 3 (Washing Aging)
When the Start key is input while 03 is ON on the display, 03 remains on the display and the washing motor runs until the
power is turned off.
The water current pattern follows that of each water level in the Fuzzy course as shown in the table of the water current pat-
tern.
The water level is detected.
7) Mode 4 (Power Relay Off)
When the Start key is input while 04 is ON on the display, 04 remains on the display and the power S/W relay is operated
up to three times of 0.5-sec ON/OFF. Then if it is not turned off, 2E is displayed and the error melody sounds 5 times.
8) Mode 5 (Water Level Sensor)
05 appears on the display during the pause. When the Start key is input, the data of the water level frequency is displayed
in 4-digit hexadecimal number.
9) When the Rinse Addition key is input while the corresponding mode is carried out by selecting a mode at the step 4), the mode
in progress is canceled to enter the mode designated by the Rinse Addition key. If the Start key is pressed at this time, the final-
ly selected mode is carried out.
SAMSUNG ELECTRONICS CO., LTD
01 02
Draining (Spin LED ON)
MR (Note 2) ML (Note 1
OFF (3 min)
03 04 05
Hot water (Hot water LED ON)
Rinse (Rinse LED ON)
11