Samsung SW12E1S(P)/XST Service Manual page 21

6-3 Shaft-Ass'y Replacement
1) Remove the 2 cover-screws (front, rear) on the control-panel by
using the (-) driver. After that, remove the 2 screws (front, rear) that
fix the control-panel by using the (x) driver. Then push the control-
panel to the front and pull it upward to separate it.
2) After removing the screws (2 on the rear, 1 on the front) that fix the
top-cover and the 1 screw that fixes the earth-wire, raise the rear
part of the top-cover ass'y and push it to the front to separate it.
3) Remove the 4 screws that fix the cover-tub and take out the cover-
tub.
4) Disassemble the pulsator-cap. Insert the (-) driver between the
pulsator-cap + the pulsator-cap and push upward to separate it.
When assembling
Align with the groove of (1) and press (2) to assemble.
Caution: If the (-) driver is inserted too deeply then pressed, it
may cause to damage the hook. Be cautious when using the
driver.
5) Loosen the pulsator fixing bolt by using the 12 mm box and
remove it.
6) Remove the 1 nut that fixes the ass'y-spin basket and the shaft
together by using the jig box and take out the ass'y spin basket.
Nut loosening direction: to the right (clockwise)
Nut fastening direction: to the left (counterclockwise)
7) Lay down the main body so that the front of the out-case faces
upward and the remove the 4 bolts that fix the saddle by using the
10 mm box.
When laying down the washer, be cautious not to break or
scratch the components. (Lay the cloth, on which to work, on
the floor.)
8) Remove the 4 bolts that fix the shaft by using the 10 mm box and
take out the shaft-ass'y. (Please check that the condition of the
shaft is same as the figure on the right.)
Assemble in reverse order of disassembling.
Since the front left side of the top-cover is fixed by the hook,
check that the hook is correctly fixed while assembling the top-
cover.
22
When disassembling
(The Condition During Washing)
(The Condition During Spinning)
SAMSUNG WASHING MACHINE