Replacing A Media Card; Verify Media Card Software And Firmware - Nortel 1000E Maintenance Manual

166 Media Card maintenance
Maintenance Corresponding Critical
Display
S002
S003
S004
S005
S006
S007
S008
S009
S010
S011

Replacing a Media Card

Replace the Media Card when the following conditions occur:
•
•
•
To replace a Media Card, see IP Line Fundamentals (NN43100-500).
Verify Media Card software and firmware
To verify the Media Card software and firmware, see IP Line Fundamentals
(NN43100-500).
Copyright © 2007, Nortel Networks
.
Error Message
ITS1002
ITS1003
ITS1004
ITS1005
ITS1006
ITS1007
ITS1008
ITS1009
ITS1010
ITS1011
After a reboot, the Media Card displays a fault code of the form F:xx
on the faceplate LED display and the card cannot register with the CS
1000E. This indicates an unrecoverable hardware failure.
If the Media Card displays the F:08 code, this can merely indicate that
the Security Device is missing from the card.
The management Ethernet interface or the voice Ethernet interface on
the Media Card fails. The failure is originating in the Media Card if its
associated hub port and TLAN network interface cable are operational.
The failure can be indicated as follows:
— No link pulse on the Media Card voice IP interface status LED and
on the associated hub.
— The maintenance terminal continuously prints lnIsa0 Carrier Failure
messages.
A voice channel on the Media Card has a consistent voice quality fault,
such as persistent noise or lack of voice path, even after resetting the
card and retransmitting the card properties.
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 01.02 Standard
Release 5.0 20 June 2007
Description
Connect service activation error <reason>.
Duplicate master <node> <ip1> <ip2>.
Invalid node ID <ip> <hwid>.
Corrupted node ID/TN field <ip> <hwid>.
Received corrupted UNIStim message <message
dump>.
Received unknown UNIStim message <message
dump>.
Terminal connection status: <ip> <status>.
Call Server communication link:<state>.
Terminal doesn't support Codec:<ip><codec>.
<IP Address>: Last reset reason for phone:
<reasonID> (<reasonString>).