To Connect Power - KVH Industries TracPhone FB250 Installation Manual

Chapter 3: Connecting power

3.3 To connect power

3.3.1 Connecting the power cable
Do as follows:
1. Connect the power cable to the ship's 24 V DC supply according to the
recommendations in the previous section.
Note
2. Connect the D-sub connector on the power cable to the DC input connector
on the terminal.
For information on pin-out, see DC power input on page 57.
For specifications of the DC input on the terminal, see TracPhone terminal on
page 112.
52
If you need a remote on/off function, connect the wires from pin
2 (green wire) and 5 (orange wire) in the power connector to a
switch or similar which can connect/disconnect these two pins.
See Connecting a Remote on/off switch on page 53 for details.
To connect power