Connect Power - KVH Industries TrackPhone V7 Installation Manual

Connect Power

10
Follow these steps to connect power to the
TracPhone V7 system.
TIP: To ensure a stable power level, KVH
recommends that you use an uninterruptible power
supply (UPS) to power the system.
a. Before you begin, disconnect vessel power.
CAUTION
For your own safety, disconnect vessel power
and make sure the circuit is dead before you
connect any power cables.
b. Be sure the vessel is properly grounded in
accordance with marine standards.
c. Connect the control unit and modem to the
supplied AC power strip (see Figure 29). Use
the special adapter cables provided in the
kitpack.
IMPORTANT!
Do not cut off the ground pin from the control
unit and modem power cable plugs, and do
not use a 3-prong to 2-prong adapter.
d. Connect the appropriate power cord (US or
European) to the power strip.
e. Connect the supplied AC/DC adapters to the
MTA, switch, and remote service & support
module. Then plug the adapter cables into
the vessel's AC power supply.
f. Strain-relieve all wires at the back of the
control unit and modem by securing them to
the attached strain-relief bracket(s) using the
tie-wraps supplied in the kitpack. Be sure to
leave enough slack in the cables for easy
serviceability.
g. Plug the power strip into the vessel's 115 or
230 VAC power supply.
IMPORTANT!
Double-check all of your wiring before
continuing. If wiring is incomplete or
incorrect, electronics may become damaged
when you apply power.
Figure 29: Power Wiring
Control Unit
AC Input
Modem
AC Pwr
J6
BUC PWR
J1 J3 J2 J8
J5
USER
AC PWR Rx RF Tx RF
CONSOLE
ENET
MODEL: VMBR-1510 ArcLight J7
PART: 1234567 REV XXX ACU
J4
SERIAL: XX-XXXXXX ENET
ACU
CAGE CODE: 12345
MTA
12 VDC
12V DC RSTR WAN LAN PHONE 2 PHONE 1
Switch
48V
8 7 6 5 4 3 2 1
+
POE 48V
Remote Service Module
Power
Power
SIM
Antenna On/Off Audio
Power
Strip
CAUTION
NO OPERATOR
SERVICEABLE
PARTS INSIDE,
DO NOT OPEN
AC/DC
Adapter
AC/DC
Adapter
AC/DC
Adapter
Vessel AC Power
(115 or 230 VAC)
15