Powering The System - KVH Industries TracPhone FB250 Installation Manual

5.2 Powering the system

5.2.1 Switching the terminal on
To switch on the terminal, use
the Power switch in the
connector panel It normally
takes one or two seconds for the
terminal to switch on.
Caution!
5.2.2 Switching the terminal off
To switch off the terminal, change the position of the Power switch again.
Note
Wait at least 5 seconds after power off, before trying to power on the
system again.
5.2.3 Remote on/off
Alternatively, you may use the Remote on/off function. In this case, leave the
power switch in the On position and switch off the terminal remotely using a
switch or similar connected to the Remote on/off pins in the DC power
interface. For further information, see Connecting a Remote on/off switch on
page 53.
When the system is powered on, stay clear of the
antenna! The antenna emits radio frequency energy, not
only when the system is used. Always keep a minimum
distance of 1.3 m from the TracPhone FB500 antenna and
0.6 m from the TracPhone FB250 antenna.
Powering the system
Chapter 5: Starting up the system
71