Changing Gobos - Chauvet Intimidator Spot 355 IRC User Manual

Changing
Gobos
Gobo Replacement Diagram
Gobo Holder Removal
Expansion Ring
Intimidator Spot 355 IRC User Manual Rev. 1
To change the gobos in the Intimidator Spot 355 IRC, do not remove the gobo wheel.
Simply:
1. Disconnect product from power outlet.
2. Place the product on a flat, level surface with the front facing up.
3. Access the gobo plate by removing the cover on the moving head. By hand, gently
push downward on the cover, in the direction of the debossed arrowhead on the
cover.
4. Rotate the gobo wheel until the gobo that needs replacing is accessible.
5. Separate the gobo holder assembly away from the gobo wheel by pushing it
forward and up. Be careful not to push the gobo out of the gobo plate.
6. Extract the gobo holder by pulling it backwards out of the product.
7. On a flat surface, remove the expansion ring that holds the gobo in place and
remove the gobo from the gobo plate.
8. Insert a new gobo and hold it in place with the expansion ring.
9. To re-insert the new gobos, slide the tip of the gobo holder under the pressure plate
near the center of the gobo wheel.
10. Push the gobo holder assembly inwards. DO NOT force the gobo holder into the
gobo wheel slot. Slightly move the holder from side-to-side if needed to get it to seat
properly. If correctly installed, the bottom of the holder will be flush with the gobo
wheel.
11. Push cover back into position.
Gobo Wheel Detail Views
Gobo
Gobo Holder
Assembly
Easy-access Panel
Page 21 of 25