Figure 40 Replacing The System Into The Chassis; E Rev - Nortel 2500 Installation Hardware

82 Chapter 6 Contivity 600 Option Installation
1
Remove the blank PCI bracket by inserting a Phillips screw driver into the
slot at the right of the blank PCI bracket and rotating the screw
counter-clockwise.
2
Lift out the blank PCI bracket, and slide the replacement card into the
intended slot.
Make sure the card seats firmly and evenly in the card slot and that the left
tabbed-end of the card is seated in its slot. If the card is not seated properly, it
will not work.
3
Replace the screw at the right end of the PCI bracket.
4
Slide the system into the chassis as shown in Figure 40.

Figure 40 Replacing the system into the chassis

5
Replace the four Phillips-head screws to secure the bottom panel.
6 Reconnect the signal cables.
7 Reconnect the power cord to restart the Contivity 600.

302283-E Rev 00

Note: Be careful not to bend the copper fingers in the slot.
I/ O E X P
A N S IO
N B A Y
C O N S O
L E
L A N 1
F D
L A N 0
R C
D C IN P
+ 1 2 V -1
-1 2 V -0 .1
+ 5 V -1 0
7 5 W M
U T
.7 A
A
A
A X
CS60004A