Replacing A Contivity 4500 Hard Disk Drive - Nortel 2500 Installation Hardware

4
Insert the new power supply. Make sure the power supply seats firmly in its
socket and is locked in. Be sure the green power LED on the front of the
power supply is on.
5
Secure the power supply screws tightly with a screwdriver.
6
Replace the front bezel.

Replacing a Contivity 4500 hard disk drive

When swapping a disk drive, you must first perform the steps listed below to
ready the switch for the swap. This process is referred to as "warm-swapping" a
disk drive.
Software
First save any data that has not yet been saved to the hard disk from the disk
cache:
1
Launch a Web browser to the switch, and go to the Admin!File System
display.
2
Click the button "Prepare selected device for removal."
Hardware
Remove the switch's front bezel as shown in
1
Insert and turn the hard disk drive key to the right. The LED becomes a "U"
for unlocked.
2
Pull the handle to remove the hard disk drive as shown in
Warning: Contivity 4500 hard disks are not hot-swappable.
NOTE: Turning the key shuts off the power to the hard disk drive.
Installing Hardware Options for the Contivity VPN Switch
Chapter 2 Contivity 4500 Option Installation 41
Figure 8, and then follow these steps:
Figure 14.