Installing Contivity 4600 Lan/Wan And Hardware Accelerator Cards; Figure 4 Installing Contivity 4600 Lan/Wan And Hardware Accelerator Cards - Nortel 2500 Installation Hardware

Installing Contivity 4600 LAN/WAN and hardware
accelerator cards
This section describes how you install option cards in the switch option card
slide-out tray. The following procedure is for Nortel Networks trained service
personnel only.
1
Turn off the switch and unplug both power cords from the power source.
2
Unscrew the four slotted thumb-screws securing the slide-out tray. Pull out
the tray by gripping it with the screws. It will only pull out halfway.
3
Remove the filler panel screw and pull out the slot filler panel.
4
Slide the option card into the intended slot. Make sure the card seats firmly
and evenly in the card slot. If the card is not seated properly, it will not work.
Populate the slots from Slot 1 to Slot 6 (top to bottom), in that order, as shown
in

Figure 4 Installing Contivity 4600 LAN/WAN and hardware accelerator cards

5 Secure the option card in the tray with the slot filler panel screw.
6
Push in the tray by gripping it with the screws. Tighten the four slotted
thumb-screws securing the slide-out tray.
Figure 4.
Installing Hardware Options for the Contivity VPN Switch
Chapter 1 Contivity 4600 Option Installation 23
CS460014A