44 Chapter 3 Contivity 2500/2000/4000 Option Installation
Figure 15 Removing the Contivity 2500/2000/4000 front bezel
The first few times you remove the front bezel it will be rather difficult to remove.
This is because the ball stud and sockets are new. After a few times, removal is
easier. Sliding the top cover back is optional; it allows you to get a better grip on
the front bezel for removal.
Remove the switch's front bezel as follows:
1. Optionally, remove the three screws at the top rear of the chassis, then
2. Slide your fingers between the front bezel and the switch.
3. Pull forward firmly.
302283-E Rev 00
slide the top cover back.
Front Bezel
Slide fingers behind
front bezel and firm ly
pull forward in the
direction of arrows.