Table of Contents
Advertisement
mf y ou purchase
the optional
chest putse sensor (see page 26), fottow the steps below to install the re-
ceiver included
with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
2, Remove the indicated 3/4" Screw (95) and the Access
Door (121) from the bottom of the ConsoUe Base (98),
3, Connect the wire on the receiver (A) to the indicated wire
extending from the ConsoUe Base (98), Hotd the re-
ceiver so the small cylinder
is oriented
as shown and
is facing the Console
Base. Attach the receiver to the
pUastic posts on the Access Door (121) with the two in°
duded small screws,
4, Make sure that no wires are pinched.
Reattach the
Access Door (121) with the 3/4" Screw (95), Discard the
other wires incUuded with the receiver,
98
SmaUU
Screws
SmaUU
'
95
HOW TO MOVE THE TREADMILL
1, Unplug the power cord,
2, Hold the treadmill with your hands in the location shown
by the arrow at the right, and raise the end of the tread°
mill. CAUTION: To decrease
the possibility
of injury,
bend your legs and keep your back straight. As you
raise the treadmill,
make sure to tilt with your tegs
rather than your back.
3, Push the treadmill to the desired location, To reduce the
risk of injury, use extreme caution while moving the
treadmill.
4, Carefully lower the treadmill until it is resting on the floor,
/
Wheels
Advertisement
Table of Contents
