BenQ SX930 Service Manual page 39

TABLE 2 :(General Product of plastic outlook inspection standard)
NO Appearance
1 缩水
Shrinkage
流痕, 咬花, 光泽
2
Run, Texture, Gloss
3 接合线
Welding Line/Knit Line
4 顶白
Ejector Mark
5 Label/screws shortage
6 缺料
Material shortage
7 色差
Chromatic aberration
8 印刷
Printing
9 Logo of panel sticker
10 刮伤
Scratch/Nicks
Spec
A 区: 不可有缩水, 以带手套检验, 手摸过去不可有凹
陷的感觉
A region: No Shrink. With gloves, no feeling of sink when touching the
surface
B / C 区: 不能明显看出
B/C region: not obvious
不能有明显的深浅不均
No obvious non-uniformity
用指甲划过不会有停顿感,并附近无明显之光泽差异
When scratching on it, there's no feeling of obstruction. Also, there
should not be obvious difference in gloss nearby it.
不可
Reject
不允许
Reject
缺料不可影响机构强度和表面
Material shortage is not allowed to impact structure strength and
surface
喷漆(Painting): ΔE<=2; L<=1.5 ; Δ A,B <= 0.6
ΔE<=2 L<=1.0; Δ A, B <= 0.6
素材(Raw material) : ΔL,A,B<=0.6 ,ΔE<=0.75
文字印刷不得有漏印、 断线、 重影、 组细不均、 溢墨、 印偏( 1mm )、
印斜 (歪斜＜0.3 mm )。
Printing must not have incomplete printing, break off, overlap,
uneven thickness, excessive ink, printing misalignment (1mm),
printing slanting & crooked (<0.3mm)
文字印刷颜色须确认是否正确 。
Printing color must be comparable to color chip and sample.
文字印刷不得有漏印.断线.重影.组细不均.溢墨.印偏( 1mm)印斜
(歪斜 ＜ 0.5 mm).
Printing must not have incomplete printing, break off, overlap, uneven
thickness, excessive ink, printing misalignment (1mm), printing slanting
& crooked (<0.5mm)
文字印刷颜色须确认是否正确.
Printing color must be comparable to color chip and sample.
Side A:
(W < 0.1mm , L < 3mm): 容许 1 个
Only 1 this kind of scratch is accepted
W < 0.1mm , L < 3-5mm 容许 0 个
No this kind of scratch is accepted
Side B:
W < 0.15mm , L < 3mm 容许 2 个
Only less than 2 this kind of scratch is accepted
W < 0.15mm , L < 3-5mm 容许 1 个
Only 1 this kind of scratch is accepted
39
银粉漆 (Paint, aluminum).
非银粉漆(Paint, non-aluminum)