Redundant Power Supply Option - HP hpe proliant dl20 gen9 User Manual

NOTE: If expansion board installed with full-height support bracket, replace with low-profile
support bracket in the expansion board kit.
Slot 1
o
Slot 2
o
Connect all necessary internal cabling to the expansion board. For more information on these
9.
cabling requirements, see the documentation that ships with the option.
Install the PCI riser cage (on page 23).
10.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all PCI slots have either an expansion slot cover or an expansion board installed.
Install the access panel (on page 21).
11.
Do one of the following:
12.
Slide the server into the rack.
o
Install the server into the rack
o
Connect each power cord to the server.
13.
Connect each power cord to the power source.
14.
Power up the server (on page 17).
15.
If removed, install the security bezel
16.

Redundant power supply option

("Installing the server into the
("Security bezel option" on page 36).
rack" on page 30).
Hardware options installation 71