Install the TPM board. Press down on the connector to seat the board
7.
on page 11).
Install the TPM security rivet by pressing the rivet firmly into the system board.
8.
If removed, install the PCI riser cage (on page 23).
9.
Install the access panel (on page 21).
10.
Do one of the following:
11.
Slide the server into the rack.
o
Install the server into the rack
o
Connect each power cord to the server.
12.
Connect each power cord to the power source.
13.
Power up the server (on page 17).
14.
If removed, install the security bezel
15.
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery
("Installing the server into the
("Security bezel
option" on page 36).
("System board
components"
rack" on page 30).
Hardware options installation 79