HP hpe proliant dl20 gen9 User Manual page 58

To install the component:
If installed, remove the security bezel (on page 17).
1.
Power down the server (on page 17).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
4.
Extend the server from the rack (on page 18).
o
Remove the server from the rack (on page 19).
o
Remove the access panel (on page 20).
5.
Remove the existing PCI riser cage
6.
Select the appropriate PCIe slot to install the M.2 SSD enablement board and remove the PCIe
7.
blank.
Slot 1
o
Slot 2
o
If installing the M.2 SSD enablement board in slot 1 do the following:
8.
("Remove the PCI riser cage" on page 22).
Hardware options installation 58