Latch - DJG Alpha Omega Instruction Manual

With weakest hand at
4
belt path, tilt and push the
child restraint forward
and back, and from side
to side. If the seat belts
do not loosen, your
child restraint should be
secure.
NOTE:
front to back or about
an inch from side to side
is acceptable. If it moves
more, review "Knowing
Your Vehicle Belts"
and "The Locking Clip"
sections.
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it, can result in
serious injury or death.
After checking for hot
5
seat and buckles, place
your child in the child
restraint as described in
the "Securing Your Child
in the Child Restraint"
section.
36
4358-5843A US All in One.indd 39-40 4358-5843A US All in One.indd 39-40
Forward-Facing Installation with
LATCH Belt: Install LATCH Belts
1
Some "play" from
2
3
4
NOTE:
Do not use
LATCH system along
with the adult lap or lap/
shoulder belt.
Route LATCH belt
through upper slot in
side of shell.
Pull one LATCH hook
across the back and out
the other side.
The LATCH adjuster
can be on either side,
but the belt should not
be twisted.
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush against
the back of the vehicle
seat back, if needed.
Fasten one LATCH belt
hook to the anchor in
the vehicle seat located
in the vehicle seat bight.
Repeat for other side of
child restraint. See your
vehicle owner's manual
for locations and more
information.
37
continued on next page.
1/26/12 11:06 AM 1/26/12 11:06 AM