TP-Link archer c50 User Manual page 99

3. Reset the router to factory default settings and reconfigure.
Note: You'll have to reconfigure the router to access the Internet once the router is reset.
1 ) Reset the router to factory default settings: press and hold the RESET button for
at least 10 seconds and then release;
2 ) Reconfigure the router with the help of
4. Please refer to "12. 3. Upgrade the Firmware"
As the follow picture shows, if the IP Address is 0.0.0.0, please try the methods below
and try again:
1. Check the physical connection.
Make sure the physical connection between the router and the modem is proper.
2. Clone the MAC address of your computer.
1 ) Visit http://tplinkwifi.net, and log in with the username and password you set
for the router;
2 ) Go to Advanced
3 ) Choose an option to your need (Enter the MAC address if
Address is selected), and click Save.
> Network > Internet;
"4. 1. Quick Setup".
to upgrade the firmware of the router.
Use Custom MAC
95