TP-Link archer c50 User Manual page 100

Tips:
• Some ISP will register the MAC address of your computer when you access the Internet for the first time
through their Cable modem, if you add a router into your network to share your Internet connection, the
ISP will not accept it as the MAC address is changed, so we need to clone your computer's MAC address to
the router.
• The MAC addresses of a computer in wired connection and wireless connection are different.
3. Modify the LAN IP address of the router.
Note:
Most TP-LINK routers use 192.168.0.1/192.168.1.1 as their default LAN IP address, it may be conflicting with the
IP range of your existent ADSL modem/router. If so, the router is not able to communicate with your modem
and cause you can't access the Internet. To resolve the problem, we need to change the LAN IP address of the
router to avoid such conflict, for example, 192.168.2.1.
1 ) Visit http://tplinkwifi.net, and log in with the username and password you set
for the router;
2 ) Go to Advanced
3 ) Modify the LAN IP address as the follow picture shows. Here we take 192.168.2.1
as an example;
4 ) Click Save.
4. Power cycle the modem and the TP-LINK router.
1 ) Power off your modem and TP-LINK router, leave them off for 1 minute;
2 ) Power on your modem first, wait about 2 minutes until it get a solid cable or
Internet light;
3 ) Power back TP-LINK router;
4 ) Wait another 1 or 2 minutes and check the Internet access.
> Network > LAN Settings;
96