TP-Link archer c50 User Manual page 76

Chapter 11
How can
I do that?
1. Change the router's LAN IP addresses to two different IP
addresses on the same subnet. Disable Router 2's DHCP
function.
2. Visit http://tplinkwifi.net, and log in with the username and
password you set for the router.
3. Go to Advanced >
4. Click
Add to add a new static routing entry.
5. Finish the settings according to the following explanations:
Destination IP: The destination IP address that you want to
assign to a static route. This IP address cannot be on the same
subnet with the WAN IP or LAN IP of the router. In the example,
the IP address of the company network is the destination IP
address, so here enters 172.30.30.1.
Subnet Mask: Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
Gateway: The IP address of the gateway device to which the data
packets will be sent. This IP address must be on the same subnet
Network > Advanced Routing.
72