TP-Link archer c50 User Manual page 14

Chapter 2
Internet
Modem
Power adapter
1 ) Turn off the modem, and remove the backup battery if it has one.
2 ) Connect the modem to the Internet port on your router with an Ethernet cable.
3 ) Turn on the modem, and then wait about 2 minutes for it to restart.
4 ) Turn on the router.
5 ) Verify that the hardware connection is correct by checking these LEDs.
Note:
If the 2.4G LED and 5G LED
and check the LEDs again in a few seconds later.
2. Connect your computer to the router.
• Method 1: Wired
Turn off the Wi-Fi on your computer and connect the devices as shown below.
Router
1
2
3
Power Internet
2.4G 5G
On On (Green)
On On
are off, please press the Wi-Fi On/Off button on the side panel for 2 seconds
Ethernet cable
Power adapter
4
10