Table of Contents
Advertisement
Compro IP55/60/70 Network Camera
Advanced
Adjust the advanced netword settings here.
DNS server
Set the DNS server address to be via DHCP or use user-specified DNS address.
NTP Configuration
Set the NTP (Network Time Protocol) server address to ensure the clock of the camera system is
synchronized to show accurate time. To synchronize camera clock via NTP server, choose either to obtain
NTP server address via DHCP server whose address needs to be provided manually, or to use an external/
public NTP server whose default address is set as pool.ntp.org.
HTTP server
Set the HTTP port for your IP camera to be viewed and controlled from the internet. Default: 80. If you
need to use port forwarding, please refer to the Port Forwarding section in this manual.
RTSP server
Set the RTSP (Real-Time Streaming Protocol) port for your IP camera to enable the support of 3GPP
streaming for mobile phones. Default: 554. If you need to use port forwarding, please refer to the
troubleshooting section for port forwarding setup.
DDNS
Click here to enable the DDNS (Dynamic Domain Name Service) service if you are using floating IP and want
to link to your IP camera using an URL. Compro iDDNS service is recommended here for use. Or if you already
have an account with DynDNS or no-ip, you can also input its domain name here for easier access to your IP
camera.
UPnP
Check here to enable/disable the UPnP feature on your IP camera installed on your local network. Also, you
can change the device name here. If your operating system supports Universal Plug and Play (UPnP™) feature
and DHCP is in use on current network, the Compro IP70 will be automatically detected and added to My
Network Places on your Windows. If you want to use the IGD (Internet Gateway Device) protocol on your IP
camera, please check the [Enable IGD] box to enable it.
RTP
If you want to broadcast video using RTP (Real-time Transport Protocol), you can set up the port range, video/
audio address and port number here.
5-8
Network Settings
Notice!
If you want to enable the UPnP™ service on your Windows, please
execute the "Add or Remove Programs" item found in "Control Panel",
and after "Add or Remove Programs" window appears, click on "Add/
Remove Windows Components" and double-click on "Networking
Services" item and check "UPnP User Interface" box and proceed to
install the component.
Advertisement
Table of Contents
