Service Cover Release Latch Assembly - HP EliteBook 8470w Maintenance And Service Manual

3.
4.
Reverse this procedure to install the RJ-11 jack cable.

Service cover release latch assembly

NOTE:
number 684339-001.
Before removing the service cover release latch assembly, follow these steps:
1.
2.
3.
4.
86 Chapter 4 Removal and replacement procedures
Downloaded from www.Manualslib.com
Release the RJ-11 jack cable from the clips (2) and routing channel built into the base enclosure.
Remove the RJ-11 jack cable.
The service cover release latch assembly components are included in the Latch Kit, spare part
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
Disconnect the power from the computer by unplugging the power cord from the computer.
Disconnect all external devices from the computer.
Remove the battery (see Battery on page
a. Service cover (see Service cover on page
b. Smart Card reader (see
c. Optical drive (see Optical drive on page
d. Hard drive (see Hard drive on page
e. Modem module (see Modem module on page
f. Keyboard (see Keyboard on page
g. Base enclosure (see Base enclosure on page
manuals search engine
57), and then remove the following components:
59)
Smart Card reader on page
61)
65)
74)
76)
80)
60)