Attaching The Optional Customer Display; Attaching The Connector Cover - Epson tm-t88v-dt User Manual

1. Make sure the product is turned off.
2. Connect each interface cable to the connectors on the back of the product. For
the position and shape of each connector, see Illustration B.
3. Connect the AC cable to the AC adapter.
4. Connect the DC cable of the AC adapter to the power supply connector on the
product.
5. Insert the AC cable plug into a power outlet.

Attaching the Optional Customer Display

If you use the product with the optional customer display, follow the steps below.
If you use the product without the customer display, skip this section and go to

"Attaching the Connector Cover."

1. Turn over the main body on its front.
2. Align the 3 screw holes on the bundled base with those on the pole mounting
plate, and secure the base with the 3 screws included in the customer display
package.
3. Pass the USB cable through the cable hole on the pole mounting plate. See
Illustration D 1.
4. Align the dowels on the L-shaped pole and the base, and attach the L-shaped
pole with the base. See Illustration D 2.
5. Connect the USB cable with one of the USB connectors.
Attaching the Connector Cover
To protect the cables, attach the connector cover in the steps below. When the
optional customer display unit is not installed, attach the connector cover with the
U-shaped part.
CAUTION:
Be sure to hold both sides of the customer display cover when attaching it,
or the connector cover may become damaged.
Note:
When pulling out the cables whose connectors do not lock themselves (USB cables and
Line-Out cable) from the cable exits on the back, fix the cables with the lock wire saddle to
prevent the cables from coming off.
1. Pass the interface cables through the locking wire saddle (E 1) on the pole
mounting plate. See Illustration E.
2. Pass each cable through the cable exits at the bottom of the connector cover.
3. If you use the product with the optional customer display, remove the U-
shaped part from the connector cover. See Illustration F. If you use the
product without the optional customer display, keep the U-shaped part
attached.
4. Align the tabs on the upper side of the connector cover with the notches on
the main body, and push the front part of it to click onto the printer cover.
5. Hold the lower part of the connector cover, align the tabs on the upper side of
it with the notches on the main body as shown in Illustration G, and push the
front part of connector cover to attach it.
6. Turn over the main body back on its bottom, and make sure the cables are not
pinched.
TM-T88V-DT User's Manual 7
English