TP-Link TL-WA701ND User Manual page 39

TL-WA701ND/TL-WA801ND/TL-WA901ND
Select the checkbox before Enable VLAN to enable VLAN function for this access point.

Configure the SSID and its corresponding VLAN ID. The detailed parameters are shown as

the above figure.
STA1, STA2, STA3 and STA4 join to the wireless network with SSID1, SSID2, SSID3 and

SSID4 respectively.
Click Save to apply the current security settings for the selected SSID.


Note:
1. The wireless STAs join to the network with different VLAN IDs cannot communicate with each
other, for example, STA1 and STA2.
2. The wireless STAs join to the network with the same VLAN ID can communicate with each
other, for example, STA1 and STA3.
3. All wireless STAs can log on to the Web management page of TL-WA901ND and manage the
access point, for example, STA1, STA2, STA3 and STA4.
4. All the packets received in the wired network from the wireless STA will be added a
corresponding VLAN Tag of the wireless STA, unless the VLAN ID of the wireless network is
set to 1.
2. Configure the Switch.
Enable 802.1Q Tag VLAN function on the switch.

Make sure the Untag frames are forwarded.

The following table shows the detailed configuration for the switch
Port VLAN ID
1 1
2 2
3 3
4 4
Port5 belongs
5
VLANs
Connect PC1, PC2, PC3 and PC4 to port1, port2, port3 and port4 of the switch respectively.

The corresponding VLAN IDs of the four ports are 1, 2, 3 and 4.
Configure port5 of the switch to be the member of VLAN1, VLAN2, VLAN3 and VLAN4 and

connect it to the LAN port of TL-WA901ND.
Configure the VLAN ID of the PC that can log on to the Web management page of

TL-WA901ND via the LAN port equal to the PVID of port 5.
3. Verify the communication status after the above configuration is completed.
If VLAN ID of the PC connected to the switch is different from the VLAN ID of the wireless

STA, the two cannot communicate with each other, for example, PC1 and STA2.
If the PC connected to the switch and the wireless STA have the same VLAN ID, the two can

communicate with each other, for example PC2 and STA2.
PVID Egress Rule
1 Untag
2 Untag
3 Untag
4 Untag
to all
1 Tag
Table 4-1 Configure the Tag VLAN Switch
31
Wireless N Access Point User Guide
Processing mode
Frames
Forwarding
Forwarding
Forwarding
Forwarding
Forwarding
of Utag